62mm Throttle Body Assembly For Jeep Cherokee Grand Cherokee Wrangler Comanche 4.0L I6 – OE 53032023AB – LOREADA

Note: For 4.0L I6 AMC 242 naturally aspirated petrol engines only. Always verify OE number before ordering.

This OEM-grade 62mm throttle body assembly is a direct throttle body replacement for Jeep Cherokee XJ, Grand Cherokee ZJ/WJ, Wrangler YJ/TJ, and Comanche MJ with 4.0L I6 AMC 242 engines (1991–2003). The 62mm bore offers a slight airflow improvement over the OEM 60mm specification. Whether you need a full throttle body replacement due to wear, a throttle body tps sensor fault, or a scheduled throttle body service, this complete assembly includes an integrated throttle body position sensor (TPS) and Idle Air Control (IAC) valve. The die-cast aluminum housing and Viton throttle body gasket seals ensure airtight fitment. Please verify your OE number before ordering.

• OEM-Grade Throttle Body Assembly – Direct replacement; resolves issues that throttle body cleaning alone cannot fix.
• 62mm Upgraded Bore – Slightly larger than OEM 60mm for improved airflow on Jeep 4.0L I6 engines.
• Integrated TPS & IAC – Complete assembly includes throttle body position sensor and Idle Air Control valve; prevents idle fluctuations and stalling.
• Wide Jeep 4.0L I6 Compatibility – Fits Cherokee XJ, Grand Cherokee ZJ/WJ, Wrangler YJ/TJ, and Comanche MJ.
• Viton Gasket & Seals – Oil-resistant fluorine rubber for long-term airtight fitment.
• 100% Factory Tested – Full stroke and response calibration before shipment.

• Type: Mechanical (Cable-Operated) with Electronic TPS & IAC
• Bore Size: 62mm (OEM 60mm)
• Engine: 4.0L I6 (AMC 242)
• Connector: Multi-Pin (TPS & IAC)
• Housing: Die-Cast Aluminum Alloy + Anti-Corrosion Treatment
• Seal / Gasket: Viton
• OE Ref: 53032023AB / 53032023AC / 56029405 / 56027942AC / 671042
• Warranty: 12 / 24 Months

Installation must be performed by a professional. This is a cable-operated throttle body assembly — no electronic drive-by-wire adaptation or throttle body relearn procedure is required. Disconnect the battery before installation. Install a new throttle body gasket (sold separately) and torque bolts to the manufacturer’s specification. After installation, verify throttle cable tension and free play. The integrated throttle body position sensor (TPS) must be set to the correct closed-throttle voltage (typically 0.5V – verify with your service manual). Check Idle Air Control (IAC) valve operation and adjust idle speed as needed. This is standard throttle body service practice for Jeep 4.0L I6 platforms. Non-professionals should not attempt installation without proper diagnostic tools.

Confirm your vehicle model matches the listing.
Compare product photos with your original throttle body assembly.
Locate the original part number (OE) on your component — look for 53032023AB, 53032023AC, or 56029405.
Contact us with your part number if unsure — our team can assist with throttle body sensor replacement compatibility and fitment questions.

Our price includes only the product and standard shipping. Buyers are responsible for all additional charges (e.g., customs duties, import fees, VAT, insurance). Customs policies vary by country – please check your local import regulations before ordering. If customs clearance fails due to the buyer’s reasons, the buyer will be fully responsible, and refunds will not be provided.