Built for US-Market Fuel Injection Systems
If your US-spec vehicle is hunting at idle, stalling at stop lights, or struggling when the A/C kicks in, the culprit is often a worn or failed Idle Air Control (IAC) Stepper Motor. The LOREADA IAC Stepper Motor OE C007H is a direct replacement engineered specifically for US-type throttle body assemblies — restoring precise bypass airflow control and stable idle speed without any modification.
Why the C007H Stands Out
Unlike generic aftermarket valves, the C007H is built to match the exact step resolution and electrical characteristics of the original US-type IAC motor. This means the ECU can communicate with it accurately from the moment it's installed — no hunting, no overcorrection, no rough idle relearning cycles that drag on for days.
Key Specifications
- OE Reference: C007H
- Market: US Type — compatible with US-spec throttle body assemblies
- Connector: US-type plug, direct fit
- Replacement type: Direct OEM drop-in, no modification needed
- QA: 100% tested for step accuracy, seal integrity, and coil resistance
Installation Notes
Clean the idle air bypass port before fitting. After installation, clear any stored idle fault codes and run an ECU idle relearn with the engine at operating temperature. Disconnect the battery beforehand to avoid triggering new fault codes during the swap.
Why LOREADA?
LOREADA manufactures IAC stepper motors in-house — from coil winding to final assembly — with full QA traceability. You're not getting a rebranded generic part; you're getting a component built to the same dimensional and electrical tolerances as the OEM unit.
Shop This Product
Order the LOREADA IAC Stepper Motor OE C007H (US Type) directly from our store and get your idle back under control.