Direct OEM Replacement | 12+24 Month Warranty | 100% Factory Tested
Vehicle Fitment – Compatible with:
Note: Production dates corrected for logical order. Please verify with your VIN.
⚠️ Important: This throttle body fits specific M266 / M271 engine variants. You must verify your original OE part number before ordering.
OE Cross Reference – Please Match Your Original Part
Common OE numbers for this application include (but are not limited to):
2661410525/ 0280750175/ 0280750176/ A2661410525/ 7519159/ V30810003
Please check your original throttle body for the exact OE number.
Technical Specifications
ℹ️ If you are unsure about connector type or bore size, please contact us with your VIN or a photo of your original part.
Product Highlights
✅ OE Fitment – Developed to strict OEM standards. Direct replacement – no wiring or programming required for most models (see adaptation notes).
✅ High Performance – Motor response time ≤ 50 ms for precise intake control and improved throttle sensitivity.
✅ Reliability – Built-in dual redundant position sensors prevent idle fluctuations, hunting, and false error codes.
✅ Rigorous Testing – 100% factory-tested for thermal cycling, airtightness, and full-stroke angle calibration.
✅ Standard Compliance – Meets ISO 16750 environmental standards for automotive electrical/electronic equipment.
Common Symptoms of a Failing Throttle Body
-
Unstable idle, "hunting," or engine stalling
-
Acceleration lag or delayed throttle pedal response
-
Check Engine Light (CEL) – common DTCs: P0120, P0220, P2119, etc.
-
Cruise control malfunction or inoperability
Installation & Adaptation Tips
IMPORTANT: After replacing the Electronic Throttle Body (ETB) on a Mercedes-Benz vehicle, a professional diagnostic scanner is REQUIRED to perform throttle alignment/adaptation.
For Mercedes-Benz: The general reset procedure (battery disconnect + key cycles) is often insufficient. Professional scanner adaptation is highly recommended to avoid driveability issues.
Packing List
-
Electronic Throttle Body Unit × 1
-
Installation Gasket / Seal (if applicable) × 1
-
Warranty Card / Quality Certificate × 1
-
(Optional: Screws / Connector protector – may vary by batch)
How to Ensure You Get the Correct Part
-
Confirm your vehicle model, chassis code, and engine code match the fitment table.
-
Locate the original part number (OE) on your existing throttle body.
-
Compare product photos with your original part (especially connector shape).
-
Contact us with your VIN or a photo of your original part if unsure.
After-Sales & Disclaimer
-
Pre-installation check: Inspect the exterior and connector pins for any deformation. Verify the OE number and plug shape before installation.
-
Compatibility: Due to variations in model years, engine types, and emission standards, if you are unsure of fitment, please provide the first 8 digits of your VIN or a photo of your original OE part for verification.
-
Warranty: This product carries a 12-month warranty against non-human damage. The motor and sensors are covered for 24 months.
